![]() Go to VPN > VPN Client and click Add Profile.ģ. On VPN Client Gateway, make sure the WAN connection is working properly.Ģ. Click Activate to enable the VPN profile.ġ. ![]() Click Save and go back to configuration page.ĩ. ![]() Configure Advanced settings on Net-to-Net VPN Server profile.ħ.1 Select IKE version to create Net-to-Net VPN tunnel,ħ.2 Select Exchange Mode for authentication information handshake.ħ.2.1 Select Main Mode for multiple rounds encrypted information handshake.ħ.2.2 Select Aggressive Mode for single round unencrypted information handshake.ħ.2.3 Note: IKEv2 can only support Main Mode, check RFC 4306 for the details.Ĩ. Go to VPN > VPN Server and click IPSec VPN tab.Ĥ. Click the Add Profile button to create a VPN profile.ĥ. Select Net-to-Net VPN Server on VPN Type and complete the following settings.Ħ. Configure General settings on Net-to-Net VPN Server profile.Ħ.2 Select the enabled WAN interface on Local Public Interface, which can be accessed from the Internet.Ħ.2.1 Note: If IP address of the selected WAN is behind of NAT gateway, please configure Port forwarding or DMZ setting for IP address.Ħ.3 Configure a Preshared Key to create a secure encrypted tunnelĦ.3.1 For example, enter iloveasus as Preshared key.Ħ.4 Define Local Private Subnet that allowed to communicate with remote subnet.Ħ.4.1 Local Private Subnet: 192.168.100.0/24.Ħ.4.2 Remote VPN Client Subnet: 192.168.200.0/24.ħ. How to set up a Net-to-Net Tunnel – BRT Seriesġ. Make sure the WAN connection is working properly.Ģ.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |